Skip to main content
  1. Assemble the LEGO® set, and set aside the two robots in the set once they have been assembled. Assemble the LEGO® set, and set aside the two robots in the set once they have been assembled.
    • Assemble the LEGO® set, and set aside the two robots in the set once they have been assembled.

  2. Once the two robots have been fully assembled, remove the main head pieces.
    • Once the two robots have been fully assembled, remove the main head pieces.

    • You won't need the old eye stalk parts-- you can set these aside.

  3. Press the new eye stalk from this kit onto the top of the robot.
    • Press the new eye stalk from this kit onto the top of the robot.

    • You may need to press with some force to attach the new eye stalk.

    • The wire is strong enough to handle being wedged around the eye stalk.

    • Feed the wire down through the head assembly and to one side of the robot.

  4. Remove the robot's side pieces and thread the wire down the side. Be careful to feed the wire between the studs, not on top of them.
    • Remove the robot's side pieces and thread the wire down the side.

    • Be careful to feed the wire between the studs, not on top of them.

  5. Carefully thread the wire through the hole in the clip on the robot's bottom part in back. Carefully pull the wire through the hole in the clip until the wire is snug against the side of the robot. Remember to make sure the wire feeds between the studs, not on top of them.
    • Carefully thread the wire through the hole in the clip on the robot's bottom part in back.

    • Carefully pull the wire through the hole in the clip until the wire is snug against the side of the robot.

    • Remember to make sure the wire feeds between the studs, not on top of them.

    • Re-attach the side parts you removed earlier.

    • You may need to press the side parts with some force to complete re-attach them.

  6. Connect the red and black power cord in this set to any one of the three plugs on the included BRANCH04 adapter board.
    • Connect the red and black power cord in this set to any one of the three plugs on the included BRANCH04 adapter board.

    • Connect power to any of the other plugs on the BRANCH04 board.

    • Head for the hills! Your evil robots are now activated.

Finish Line

One other person completed this guide.

Rob K

Member since: 06/18/2012

45 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 3

All Time: 756