Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #7

Edit by Rob K

Edit approved by Rob K

Before
After
Unchanged

Step Lines

[title] Feed the Wire
[* black] As shown in the first photo, pull the wire up through the space above the wheel well.
[* black] As shown in the second photo, on the underside of the car, remove the black "boat stud" on the right side, and hold the wire so it is '''BETWEEN '''the four studs shown by the four red circles in the photo.
[* icon_caution] It is critical that the wire run between the four studs, so that when the "boat stud" part is re-attached, its studs do not pinch any wires. The wire must run in the gap between the studs.
[* black] As shown in the third photo, re-attach the "boat stud" so it holds the wire in place.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added