/
/

Site Navigation

Your Account

Choose Language

Changes to Step #10

Edit by Rob K —

Edit approved by Rob K

Before
After
Unchanged

Step Lines

[title] Verify Wire Placement
[* black] Make sure the wire runs the way it isAs shown in the first photo.
[* black] As shown in the second photo, re-attach the gray 1x4 brick on the inside of the Ecto-1. This should hold the wirepart you removed in placeStep 6.
[* icon_note] beforeicon_caution] When re-attaching the 1x4 brickpart, make sure the wire isthree wires are pulled tight underand that they run between the Ecto-1. This is necessary sostuds underneath the wire does not rub against the wheelpart.
[* black] As shown in the third photo, re-attach the wheel, and spin it tosecond photo (red arrows), make sure the wheel doeswires are tight enough so they will not rub against the wirewheel.
[* icon_note] Ifblack] Re-attach the wheel rubs againstwheel. As shown by the wire, removered box in the wheel, remove the 1x4 brick inside the Ecto-1, pull the wire tighter, and re-attach the parts again, double-checking tothird photo, make sure your wires run so they are not loose and so they do not rub against the rubbing has been fixedwheel.
[* black] Make sure the wire runs the way it isAs shown in the first photo.
[* black] As shown in the second photo, re-attach the gray 1x4 brick on the inside of the Ecto-1. This should hold the wirepart you removed in placeStep 6.
[* icon_note] beforeicon_caution] When re-attaching the 1x4 brickpart, make sure the wire isthree wires are pulled tight underand that they run between the Ecto-1. This is necessary sostuds underneath the wire does not rub against the wheelpart.
[* black] As shown in the third photo, re-attach the wheel, and spin it tosecond photo (red arrows), make sure the wheel doeswires are tight enough so they will not rub against the wirewheel.
[* icon_note] Ifblack] Re-attach the wheel rubs againstwheel. As shown by the wire, removered box in the wheel, remove the 1x4 brick inside the Ecto-1, pull the wire tighter, and re-attach the parts again, double-checking tothird photo, make sure your wires run so they are not loose and so they do not rub against the rubbing has been fixedwheel.

Image 1

Old Version

New Version

Image 2

Old Version

New Version

Image 3

Old Version

New Version