Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #9

Edit by Rob K

Edit approved by Rob K

Before
After
Unchanged

Step Lines

[title] Run the Speaker and Power Wires
[* black] As shown in the first photo (see the blue arrow), pull the speaker wire up into the main body of the car like you did with the wire from the front hood.
[* black] As shown in the second photo, connect the 6" black connecting cable to one of the plugs on the BRANCH04 adapter board, and attach it to the bottom rear of the car using a sticky square.
[* black] Carefully run the black wire as shown in the second photo (purple lines) by removing "boat studs", running the wire between studs underneath, then re-attaching the "boat studs".
[* icon_caution] Make sure not to pinch any wires under any of the studs when re-attaching the "boat studs".
[* icon_caution] Make sure the black wire follows the path shown by the purple lines in the second photo-- it must not rub against the wheel axle or cause friction when the wheel turns.
[* black] As shown by the blue square in the second photo, use this "boat stud" to hold three wires: the wire coming from the hood, the speaker wire, and the black cable.
[* black] As shown in the third photo, pull the black cable up into the main body of the car.
[* icon_note] You should now have all three wires pulled up into the main body of the car. Make sure the wires are pulled tight underneath so they don't rub against the wheel.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added