Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #14

Edit by Rob K

Edit approved by Rob K

Before
After
Unchanged

Step Lines

[title] Connect Wires to the Roof
[* black] Take the pre-wired roof assembly out of its anti-static bag.
[* black] As shown by the red circles in the first photo, insert the two black power wires into the two large connecting plugs under the roof.
[* icon_note] The photo shows the main power wire connected to the front plug and the tail lights connected to the rear plug, but you can connect either wire to either plug.
[* black] As shown in the second photo (blue square), carefully insert the 3-wire plug (from the front hood assembly) into the plug under the roof labeled "PIXEL".
[* icon_note] Use your fingernail to press the 3-wire plug all the way into the PIXEL connector. If you later find that the hood lights do not work, it is likely because this plug is not fully inserted.
[* icon_caution] Note that the plugs will only insert one way-- do not force them.
[* black] Finally, connect the speaker wire as shown in the third photo. Make sure the two white dots on the plugs are aligned when connecting as shown by the two red arrows.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added