Skip to main content

Changes to Step #15

Edit by Rob K

Edit approved by Rob K

Before
After
Unchanged

Step Lines

+[title] Attach Left Rear Turn Signal
+[* black] Open Bag 1 (labeled "Core Parts") and carefully remove the parts inside. Lay on a flat surface where you won't lose any parts.
+[* black] As shown in the first photo, use on the sticky squares included with your kit to mount one of the red Pico LEDs from Bag 1 to the ***LOWER ***turn signal cover as shown.
+[* black] As shown in the second photo, route the left rear turn signal wire through the small hole above the black rear plate (red circle)
+[* black] As shown in the third photo, make sure the wires run ***BEHIND ***the yellow shock absorbers (green rectangle) and through the hole in the blue beam (green arrow).

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added