Skip to main content

Changes to Step #23

Edit by Rob K

Edit approved by Rob K

Before
After
Unchanged

Step Lines

[title] Connect the Headlight Cable
-[* black] In this step, you will connect the 3-wire headlight cable to the main controller board.
-[* black] As shown in the first two photos, route the 3-wire headlight control cable into the same area as the main controller board.
-[* black] As shown by the green arrows in the third photo, connect the 3-wire headlight control cable to the SENS2 plug in the upper right corner of the main controller board.
+[* black] In this step, you will connect the 3-wire headlight cable to the TRUNK11 effect controller board.
+[* black] As shown in the first two photos, route the 3-wire headlight control cable into the same area as the TRUNK11 effect controller board.
+[* black] As shown by the green arrows in the third photo, connect the 3-wire headlight control cable to the SENS1 plug in the upper left corner of the TRUNK11 effect controller.
[* icon_caution] The plug will fit only one way-- do not force. Press the plug in with your fingernail-- you will feel a "click" when the plug is fully inserted.

Image 1

Old Version

New Version

Image 3

Old Version

New Version