Skip to main content

Changes to Step #26

Edit by Rob K

Edit approved by Rob K

Before
After
Unchanged

Step Lines

+[title] Route Tail Light Wires
+[* black] Mount both "blaster" assemblies, one on the left side and the other on the right side of the rear of the car.
+[* black] As shown in the first two photos, one "blaster" assembly will have its LED wires extending upward, and the other will have its wires extending downward.
+[* black] As shown in the third photo, you may need to remove some parts on top, and possibly the large black plate on the rear of the car itself, in order to route the tail light wires.
+[* green] As shown by the green circle in the third photo, you may need to remove these parts in order to allow the black shrink-wrapped portion of the cable (which is thicker than the wire) to pass through.
+[* black] Route the wires for both the left and rear tail lights, and re-attach any parts you removed to allow the wires through.
+[* icon_note] ***The following step has some additional tips for successfully routing the wires.***

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added