Skip to main content

Changes to Step #29

Edit by Rob K

Edit approved by Rob K

Before
After
Unchanged

Step Lines

[title] Connect Tail Lights to Main Controller Board
[* black] Remove the 4-port BRANCH15 adapter board from Bag 1, and also pick up another 1.5" black connecting cable from the same bag.
[* black] As shown in the first photo, carefully connect the two tail light plugs to any two of the small plugs on the BRANCH15 adapter board.
[* icon_note] Remember, plugs will only insert one way-- do not force. Use your fingernail to press the plugs in all the way.
[* black] As shown in the second photo, connect the black 1.5" connecting cable to either one of the large connectors on the BRANCH15 adapter board.
-[* black] As shown in the third photo, connect the 1.5" connecting cable to the main control board as shown. For proper operation, it is critical that you connect the cable to the specific connector shown by the green square.
+[* black] As shown in the third photo, connect the 1.5" connecting cable to the TRUNK11 effect controller as shown. For proper operation, it is critical that you connect the cable to the specific connector shown by the red box (labeled OUT3).
[* icon_note] The other two small connectors on the BRANCH15 adapter board are for additional (optional) lights. One of the plugs is used by our spoiler add-on kit, and the other could be used for an interior or engine light (purchase a warm white Pico LED separately).
-[* icon_note] The other large connecting plug on the BRANCH15 adapter board can be used to connect more lights, such as blue underbody LEDs (purchase blue Pico LEDs, cables, and adapter boards separately).

Image 1

Old Version

New Version

Image 2

Old Version

New Version

Image 3

Old Version

New Version