Skip to main content

Changes to Step #30

Edit by Rob K

Edit approved by Rob K

Before
After
Unchanged

Step Lines

+[title] Insert Tail Light Fiber Optic Tube
+[* black] Carefully insert the long, clear fiber optic tube into the holes in the two "blaster" assemblies (one on each side of the rear of the Bugatti).
+[* icon_note] Note that the "blasters" have little black tubes inside to block sideways glow of the red LEDs.
+[* black] Snap the clear fiber optic tube into place on the rear of the car.
+[* icon_note] For daytime display, you can still use the original red piping that came with your LEGO® set-- just remove the Brickstuff clear tubing and replace with the original LEGO® red tube.
+[* icon_note] Note that the Brickstuff red LEDs will not illuminate the original LEGO® red tube.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added