Skip to main content

Changes to Step #32

Edit by Rob K

Edit approved by Rob K

Before
After
Unchanged

Step Lines

+[title] Mount Pico LED
+[* black] As shown in these three photos, remove the center mount from the roof beam, and then feed the cable of the cool white Pico LED through the Technic pin hole.
+[* black] As shown in the third photo, the LED cable should come through the slot in the black Technic pin, and the LED should bend to face toward the blue Technic beam.
+[* icon_note] The "front" of the LED is the side opposite where the wires are soldered. You can see a small white rectangle on the front of the Pico LED-- this is the LED chip itself.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added