Skip to main content

Changes to Step #35

Edit by Rob K

Edit approved by Rob K

Before
After
Unchanged

Step Lines

+[title] Connect Interior LED
+[* black] Taking the Pico LED cable you routed in the last step, connect it to one of the small connectors on the last BRANCH03 adapter board from Bag 1, and use the last 1.5" black connecting cable to connect the interior LED to the last open plug on the master control board as shown by the red arrow in the third photo.
+[* icon_note] Now would be a good time to double-check that you have all lights connected to the correct plugs on the main controller board. Only one plug should still be open: the single plug at the bottom of the board (blue square, third photo). This is where you will connect the power supply in a later step.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added