Skip to main content

Changes to Step #42

Edit by Rob K

Edit approved by Rob K

Before
After
Unchanged

Step Lines

+[title] Connect the Spoiler LEDs
+[* black] As shown in the first two photos, remove the two rear side panels and left/right beams if needed to allow the rear roof section to open up.
+[* black] Route the wires as shown in the second photo, making sure the wires go behind the yellow shock absorbers as shown by the red square.
+[* black] As shown in the third photo, connect the spoiler LED cable to one of the available small connecting plugs on the BRANCH15 adapter.
+[* icon_note] The spoiler LED cable will just reach the BRANCH15 adapter board-- make sure you have routed the wiring so there is no extra slack, or the cable may not reach.
+[* black] Close up your Bugatti and re-attach the beams and panels you removed at the beginning of this step.
+[* icon_note] The spoiler LEDs will now turn on and off along with the main tail light (fiber optic bar).

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added