Skip to main content

Changes to Step #21

Edit by Rob K

Edit approved by Rob K

Before
After
Unchanged

Step Lines

+[title] Connect RF Receiver to Main Effect Controller
+[* black] Remove the main effect controller (labeled TRUNK11 on the back side) from Bag 1. The first photo shows the TRUNK11 controller.
+[* black] There should be a separate clear bag included with your kit that has the white remote and a small circuit board with black antenna. The second photo shows the circuit board and its attached cables. This is the RF receiver board.
+[* icon_note] The photo shows a receiver board with very short wires. Your receiver will have longer wires. You can coil up the excess wire inside your Bugatti after installation.
+[* black] As shown by the blue arrow in the third photo, connect the large plug from the RF receiver board to one of the power plugs on the TRUNK11 effect controller (it does not matter which power plug you use).
+[* black] As shown by the green arrow in the third photo, connect the smaller cable from the RF receiver board to the plug labeled "REMOTE" on the TRUNK11 effect controller.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added